TABLE OF CONTENTS

Part 1: Introduction
1.1	Safety Considerations
1.2	Before you Begin

Part 2: Setup
2.1	Mounting the Controller
	Figure 2.1a - Square Mount
	Figure 2.1b - Round Mount
2.2	Front Panel View
	Front Panel Annunciators
2.3	Rear Panel View
	Rear Panel Connector Labels
2.4	Mechanical Installation
	Dip Switch Configuration
	Figure 2.4 - Dip Switch Location
	Dip Switch Settings
2.5	Electrical Installation
	Figure 2.5.2 - Thermocouple Wiring Hookup
2.5.1	Thermocouple - Input Connection Examples
2.5.3	Two / Three / Four wire RTD Hookups Figure 2.5.3
2.5.4	Process Current Wiring Hookup Figure 2.5.4
2.5.5	Process Voltage Wiring Hookup Figure 2.5.5

Part 3: Operation: Configuration Mode
3.1	Introduction
	Turning your controller on for the first time
	Function in configuration mode
3.2	Menu Configuration - Figure 3.1 - Flowchart
	ID Number
	Set Points
	Input Type Figure 3.2 - Flowchart
	Input Type (Thermocouple)
	Input Type (RTD)
	Input Type (RTD Value)
	Input Type (Process)
	Reading Configuration Figure 3.3 - Flowchart
	Alarm 1
	Alarm 2 Figure 3.4 - Flowchart
	Loop Break Alarm Figure 3.5 - Flowchart
	Output 1 Figure 3.6 - Flowchart
	Output 2 Figure 3.7 - Flowchart
	Ramp and Soak Figure 3.8 - Flowchart
3.3	Available Options
	Analog Output Option Figure 3.9 - Flowchart
	Communication Option Figure 3.10 - Flowchart
	Communication Commands
	Command Letters & Index
	Remote Setpoint Option Figure 3.11 - Flowchart

Part 4: Specifications
	Specifications
	To Order
WARRANTY / DISCLAIMER
NOTES, WARNINGS AND CAUTIONS Information that is especially important to note is identified by three labels: NOTE WARNING CAUTION IMPORTANT Note: provides you with information that is important to successfully setup and use the Programmable Digital Meter. CAUTION or WARNING: tells you about the risk of electric shock. CAUTION, WARNING or IMPORTANT: tells you of circumstances or practices that can effect the meter's functionality and must refer to accompanying documents.